Filling The Tank - Hkoenig V26 Manual De Utilización

NOTE: Continue to release steam for long time, when pump adds water into boiler,
soleplate will stop to release steam for short time, almost 10secs.
DRYIRONING
Connec! the appliance to the mains
temperature by turning the thermostat knob(4).Wait until the iron heating indicator light (2) goes
indicating that the desired temperature has been reached.
For dry ironing it is not necessary to press the steam button (3).

FILLING THE TANK

Thanks to the self-filling
fills up again.
When the water in the boiler is at minimum
the boiler once again.
If you hear the loud feed-water sound when you
tank (14).Press the switch button (7) and eut down the
press the switch button (7) again, go on ironing.
To keep on working, simply restore the water level in the self--refilling tank as described in the
"Preparation for use"
PUTTNG THE APPLIANCE AWAY
First ensure that the appliance has cooled down completely.
Empty the water tank ( 14)
lt is not necessary to drain the boiler after ironing.
Steam line (5) and power cord (9) could be receipt into the wire groove (12) and line box
LOCKING IRON
To Iock the iron it must be set on the rear part of the rest mat (Fig11).
NOTE: make sure to firmly hook the iron to prevent it falling accidentally.
CARE OF YOUR STEAM IRONING
Before attempting any maintenance
To clean the body of the
which may harm the body
Always keep the surface the ironing plate perfectly
with a damp cloth. The appliance must not be cleaned with descaling agents.
Do not iron over zippers, hooks, rings, etc; as these may scratch the plate.
When you have finished
traces of water under the
Store the appliance in a dry place
PERIODIC CLEANING OF THE BOILER
To maintain optimum performance, clean the boiler every 10/20 uses depending on the amount
of limestone in the water.
Disconnect the appliance and let it cool down for at least 2
After the appliance refrigeration enough put up one side of the cleaning valve
rotate counterclockwise the cleaning valve (Fig.5) (do not
the cleaning valve, otherwise the water will
CAUTION! Never attempt to open the cleaning valve ( 11) while the boiler is under pressure.
CAUTION: do not pour more than 200ml water into the boiler. Pour water slowly, being careful
not tolet il overflow,
Rinse out the boiler and pour the water away into the sink or into a container for collecting dirty
supply,
function, there is no longer any need to stop and wait while the boiler
paragraph.
.
operation,
appliance, simply use a moist cloth. Do not use solvents or detergents
material.
ironing. Place the iron correctly on its stand. Ensure that there are no
plate, as these may cause stains.
leakage).
as this could damage the
press the switch button(7),
level, the pump is automatically activated which fills
ironing, it means there is no water in the water
power. After fill the water tank
always disconnect the appliance from the mains.
clean. To clean
hours.
fiat the appliance when you open
lie
appliance.
then select the desired
(14),
(10).
it, jus! wipe the cold surface
(11), forced to
off,
then