Klarstein Hot Spot Crystal Flow Manual Del Usuario página 31

Plug in supply of 220-240V~ 50Hz, push the ON/OFF (0/I) button located at the
bottom of the heater to switch it on. Buzzer will have a short "D" sound. Display will light
up for 10s.
Touch once to turn on heating. Button light will go out in 10s when no operation is
conducted. Touch any button could reactivate the button light.
Touch once again to turn off heating & appliance stay at standby mode.
Note: Motor will continue working for extra 15s to drive away the residue heat inside
unit before turning off.
To switch the appliance off, push ON/OFF (0/I) button again and disconnect the plug.
Set local day and time
At the first time usage, icon
time before further operation.
Long touch button for 3 seconds to activate timer setting,the display will show d1
(Monday) and flashes, touch  or  to select the day, the selected figure will flash
accordingly. Touch to confirm the day setting. Then come to hour-setting. The display
flashes, touch  or  to select the hour among 0-23, touch
Then come to minute-setting. The display flashes, touch  or  to select the minute
among 0- 59. Touch to confirm minute setting.
Note: program will automatically return to initial display in 10s when no operation is
conducted during setting.
Power Setting
PTC heating high power
PTC heating low power
Panel Heating
Full power
will keep flashing to remind user to set local day and
Power Icon Display
1800 W
1 100 W
200 W
1800 W +
200 W
= 2000 W
to confirm hour setting.
Function
Room heating
Room heating
Towel heating
Room heating +
towel heating
EN
31