Descargar Imprimir esta página

Micro Matic smartDRAFT Instrucciones De Funcionamiento página 5

Ocultar thumbs Ver también para smartDRAFT:

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning instructions for the smartDRAFT™ Tap
Wipe with a damp clean soft cloth if required. Do not use soap.
!
Do not use dishwasher!
Technical specifications smartDRAFT™ Tap
Dimensions in mm
Height
Width
Length
Dispatch weight in kg
Flow (covers all beer types with 4.5-5.5 g
CO
/l in a temperature range of 3-8 °C
2
Micro Matic A/S assumes no responsibility for errors, if any, in catalogues, brochures, and other printed matter. Micro Matic
A/S reserves the right to modify its products without prior notice, including already ordered products, if this can occur without
changing already stated specifications. All right reserved.
smartDRAFT™ and its components are protected by several patents.
See also smartDRAFT™ Cooler manual.
7
!
186
124
346
1.75
1.6-2.0 l/minute at pre-set pressure
of 1.0 bar
Trouble shooting for bar staff
Problem
Reason
No beer flow, when
Tap not connected correctly
dispense handle is pulled
One-way beer line has been used once
One-way beer line is defective
Tap is defective
Beer is too warm
No beer in the keg
No CO
in the keg
2
Non return valve in main piston glued with beer
Beer is foaming
Handle is not opened completely
Handle is opened/closed too slowly
Glass is too warm
Beer is too warm
One-way beer line is defective
Too less foam
Beer glass is not clean
No CO
in the keg
2
Beer too cold
Beer is too warm
Keg is not prechilled
Cooler is/was not connected to electricity
Cooler is not adjusted correctly
Cooler is defective
Beer is too cold
Temperature of prechilled keg too low
Cooler is not adjusted correctly
CO 2 is leaking
Tap not connected correctly
No one-way beer line installed
One-way beer line is defective
Tap is defective
Keg is defective
O-ring on main piston is broken
Beer is leaking
One-way beer line is defective
Gasket in keg defective
Only gas is coming out,
Keg is empty
when handle is pulled
One-way beer line has already been used once
Solution
Open and close tap cover again
Replace one-way beer line
Replace one-way beer line
Contact brewery
See problem "beer is too warm" below
Replace keg
Replace keg and contact brewery
Flush piston with warm water for short term
solution. Exchange main piston for long term
solution
Open handle completely
Open/close handle fast in one move
Cool glass with cold water before dispensing
See problem "beer is too warm" below
Replace one-way beer line
Clean glass with beer glass cleaner
Replace keg and contact brewery
See problem "beer is too cold" below
Take prechilled keg
Cool down keg in cooler (~ 3 hours)
Keep cooler connected when a keg is
connected
Contact brewery
Contact brewery
Check temperature prechiller
Contact brewery
Open and close tap cover again
Install one-way beer line
Replace one-way beer line
Contact brewery
Replace keg and contact brewery
Exchange O-ring
Replace one-way beer line
Replace keg and contact brewery
Replace new keg
Install new one-way beer line
8

Publicidad

loading