Settings - hager EE610 Manual De Instrucciones

Settings

/
Detection zone
Optimal installation height is 2 m.
The detection zone shall remain free of obstacle.
Default detection area (set at factory)
Remotely adjustable maximum detection area (EE806 / 52900)
8
Temporisation A Brightness
(duration of operation of
the LED light source)
A B
Testing and validating
the detection zone
B
Put the potentiometer
The "test" mode is available for 3 min. Every
movement detected switches on the light for 1s.
After 3 min without detection of movement, the
product returns to normal operation.
"Normal" operation (on/off)
The lamp is lit when the brightness level set by
potentiometer
B
movement is detected.
After detection, the light stays on for the length
of time predefined by the potentiometer
The fixed timing is reset after each detection.
Please note : when the potentiometer
"auto test", the settings are predefined (see table
below).
B on "test" mode.
is judged insufficient and a
A .
B is on
6LE000756E