Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 1
Fig. 2
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will
be affected and may cause you Fridge/Freezer to work incorrectly. Once
the Fridge/Freezer is placed in its final location, adjust the leveling feet at
the front by turning them.
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing in the Fridge/Freezer. The external parts of the Fridge/Freezer can be
cleaned with wax polish.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the Fridge/Freezer.
Before switching on!
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your Fridge/Freezer
Before storing foods in your Fridge/Freezer, turn the Fridge/Freezer on and wait for 24 hours, to make
sure it is working properly and to allow the Fridge/Freezer drops to the correct temperature.
Electrical Connection
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged,
have it replaced by an authorized service center.
This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
220-240V A.C. ~/50Hz
This refrigerator requires a standard
electrical outlet with three-prong ground.
This refrigerator is not designed to be used with an inverter.
The cord should be secured behind the refrigerator and not left exposed or dangling to prevent
accidental injury.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out
from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance. Use of an extension cord can
negatively affect the performance of the unit.
★Installing your refrigerator
If the refrigerator couldn't through the room door smoothly, you can remove the refrigerator door at first.
(1)The freezer door
(a).Closing the freezer door and removing the top hinge A, then tearing down the wire gently
11
Publicidad
