Product Specifications - Project Source 553400 Guia De Inicio Rapido

SAFETY INFORMATION
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble
the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Groove Joint Pliers, Pipe Wrench,
Phillips Screwdriver, Supply Lines, PTFE Tape and Silicone
Installations may vary depending on how the previous faucet was installed. Supplies necessary
for the installation of the faucet are not all included; however, they are available wherever plumbing
supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn on the old faucet to
release built-up pressure. When installing the new faucet, hand tighten the connector nuts. DO
NOT OVERTIGHTEN. Connections that are too tight will reduce the integrity of the system.

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. flow rate: 1.8 GPM (6.8 LPM) at 80 PSI
ASME A112.18.1/CSA B125
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve at the main water supply,
disconnect the supply lines, and remove old shower head and
faucet body.
Clean and dry surface area where new shower will be mounted.
2.
Position Unit
Spread a small amount of silicone (not included) on the surface of
the bottom plate facing the wall on faucet body (A). Position faucet
body (A) through holes of wall.
Align faucet from back side of mounting surface and secure by hand
tightening mounting nuts (AA). THE BOTTOM PLATE MUST BE
USED.
SPECIFICATIONS
Washerless cartridges
Total weight of item: 0.866 lbs.
3
1
2
AA
A