Cojali jaltest JT3013 Manual De Instrucciones página 7

INSTRUCTIONS: LED WORK LIGHT
1. Press the "USB/LAMP" reset switch on the panel 3 (Continuous
pressing time > 3 seconds).
2. The light works and enters the strong light mode. Press the switch again to
enter the soft light mode, press the switch again to enter the flash mode,
press the switch again to enter the slow flash mode, press the switch
again to enter the SOS mode, and then press the switch again to close the
switch.
3. After working continuously for more than 5 seconds in any working mode,
you can also turn off the switch by pressing the switch.
REPAIR - BATTERY REPLACEMENT
The battery can be used for 3-7 years under good maintenance conditions.
Replacement steps:
1. Unscrew and remove the fastening screw of the bottom rubber pad, and
then unscrew the rear case fastening screw.
2. Separate the rear case and you can see the battery compartment.
3. Remove the battery from the battery compartment.
4. Disconnect the wire from the battery poles.
5. Replace the battery and put a new battery in the same direction.
6. Connect the starter wire and other wires to the battery terminals. Make
sure the red start wire and other red wires are connected to the positive
(+) side of the battery (the positive is also red), and the black start wire and
other black wires are connected to the negative (-) of the battery.
7. Put new battery in battery compartment.
8. Reposition the back cover and fasten it with screws, then install the rubber
pad and fasten it with bolts.
9. Old batteries are recycled and disposed of according to the regulations of
the authorities.
10. After the assembly is finished, open the panel switch and check that all
functions are intact and you can complete.
Note: Install the battery, the polarity can not be reversed, and the direction
of the battery connection terminal should be correct to avoid affecting the
cover.
7