EXALTA EL-400 Manual Del Usuario página 8

imp. JC 486 rev 00:imp. JC 486
necessary to empty the collection bin as soon as the special
indicator (1) lights up.
CLEANING AND MAINTENANCE OF
THE APPLIANCE
- Before emptying the bin, please place the control dial (3) in
OFF position and then unplug the unit from the mains.
- Remove the collection bin from the main unit by the special
handle (12).
- Open the collection bin cover (11) and turn the bin upside
down over a trashcan. Make sure you empty all the dirt and
debris from inside and below the bin. If necessary, please
shake the bin so that all the debris comes out.
- If necessary clean air inlets and the bin by a soft cloth
damped with water. As regards the photocells, please clean
them by a dry brush.
- Please close the bin by the special cover (11)
- Insert the collection bin into its original position.
IMPORTANT: for all the people suffering from allergies and/or
asthma, it is advisable to empty the collection bin outdoor (for
instance staying in the terrace).
INNER filter cleaning
In order to always grant a good performance to the product,
INNER filter (10) should be constantly cleaned. Please proceed
with the cleaning also when the suction power is not as strong
as usual.
1. Place the control dial (3) in OFF position and unplug the unit
from the mains.
2. Open the collection bin and remove it from the main unit.
3. Open the filter door, turning its cover counter-clockwise to
"un-lock" position (image 3)
4. Wash the filter under running water.
IMPORTANT: before inserting the INNER filter into the
collection bin, please be sure it is well dry.
5. Put the filter into the collection bin and close the cover
turning it clockwise.
WARNING: never use the unit without INNER filter properly
placed.
Outer air filter cleaning
1. In order to remove the outer filter, please slide it up (Figura
4 – nr 14) and to insert it, just slide it down.
2. Remove the filter from its support (Figura 5-nr 15) and beat
it in order to remove excess dirt and debris.
3. If necessary, you can also wash the filter using a mild soap
and water; then rinse and dry the filter carefully before
inserting it into its support and using the appliance.
4. When you insert the filter into its support, please place the
white side facing outwards.
WARNING: never operate the appliance without the air filter
properly in its place.
30-07-2009 8:32 Pagina 8
Collection bin cleaning
1. Collection bin must be periodically washed
2. Please remove the INNER filter (10) first from the collection
bin.
3. Wash the bin in warm water using a mild soap. Avoid harsh
or abrasive cleaners or sponge. Rinse thoroughly and dry
carefully before inserting the bin into the main unit.
NEVER WASH THE COLLECTION BIN IN THE
DISHWASHER.
UNIT STORING
Place the control dial (3) in OFF position and then unplug the
unit from the mains. Empty the collection bin and if necessary,
clean filters.
Store the appliance in a close, clean and dry place. Never store
the unit if it is still connected to the mains.
Do not pull excessively the cable, as it can cause the cable to
wear and break.
WARNING!! TO REDUCE ANY RISK OF ELECTRICAL
SHOCK, NEVER USE THE PRODUCT ON WET
SURFACES. DO NOT EXPOSE THE APPLIANCE TO THE
RAIN AND STORE IT ALWAYS INDOOR.
POWER SUPPLY: 220/240V ~50 Hz - 1400W
8
Do not use this appliance near bathtubs, showers,
basins or other vessels containing water.
Class II appliance
This item is made in conformity with all the
applicable European directives