Troubleshooting - EXALTA EL-400 Manual Del Usuario

imp. JC 486 rev 00:imp. JC 486
TROUBLE SHOOTING
PROBLEM
The unit does not light up
The unit does not pick up
debris
Photocells do not activate
Suction power is not so
strong
Functioning LED indicator
is blinking
Full collection bin
indicator is ON
Debris in the collection
inlet
NOTE: Specifications and designs are based on the latest information available at the time of printing and subject to change without
notice
DISPOSAL
The device (including its removable parts and accessories) must not be disposed of together with municipal waste at the end of its
life, but in compliance with European Directive 2002/96/EC. Since it must be handled separately from household waste, either carry
it to a separately collected waste disposal centre for electrical and electronic appliances or give it back to the retailer on purchasing
a new device with the same purpose. Any infringement will be severely prosecuted.
Specifications and designs are based on the latest information available at the time of printing and subject to change without notice.
30-07-2009
POSSIBLE CAUSE
1 The unit is not correctly plugged in
2 Control dial in OFF position
3 Filter is not in its position
4 No power in the wall plug
5 Troubles to the house electrical circuit
1 Dirt collection inlet is blocked
2 Collection bin is full
3 Debris are too big to be collected
Control dial is not in AUTO position
Dirt filter
Photocells have been shutted off for 30 seconds
consequently motor switches off
1 Collection bin is full
8:32 Pagina 9
POSSIBLE SOLUTION
1 Plug correctly the unit
2 Place the control dial in MAN or AUTO posi-
tion
3 Insert the filter in the bin
4 Check house switches are properly switched
on
5 Ask an specialized technician to check the
house circuit
Place the control dial in OFF position:
1 Clean the inlet
2 Empty the collection bin
3 Remove big debris
Place the control dial in AUTO position
Place the control dial in OFF position:
Clean both filters (if necessary)
Place the control dial in OFF position:
1 Check both filters and if necessary clean or
replace them
2 Clean photocells
3 Place the control dial in AUTO position
Place the control dial in OFF position:
1 Empty the container
2 Clean all dirt filters
1 Place the control dial on MAN
2 Activate unit manually
9