Northern Tool Mobile Link Manual Del Usuario página 26

18. Lift the controller to gain access to the accessory plug location.
If there is a decal labeled "Port 1", remove decal to locate con-
nector. If there is no decal, locate the open eight pin connector
on the underside of the generator controller. See Figure 3-14.
Install the harness eight pin connector into the controller's
open socket.
NOTE: The connector will only fit one way. DO NOT force.
19. For Nexus or Sync controllers, locate the port on the under
side or the controller. It may be covered with a decal. If so,
remove the decal and install the harness. Figure 3-15.
Figure 3-15. Harness Installed to Controller
20
Figure 3-14. Raising Controller
Mobile Link