Operation; Manual Operation - Dimplex VF5452L Manual Del Propietário

Operation

Figure 2
A B C
IR Remote Sensor
WARNING: This
be properly installed before it
is used.
The power switch
first be switched "I" to operate the
appliance.
An 'Opti-V' logo will appear on
the screen for about 3 seconds
before the flame picture starts .
! NOTE: The user may notice
a blank screen for
approximately 5 seconds,
every 30 minutes. This is
normal and should not be a
cause for concern.

Manual Operation

The manual controls for the
screen are located at the inner
top left hand side of the appliance
above the glass.
The mains (power) switch
may be used to switch the
2A)
10
D
Opti-V must
(Figure 2A)
.
(Figure 2)
(Figure
appliance Off ('O') when it is not
required, for example, overnight
or for long periods, to avoid
unnecessary energy use.
must
! NOTE: Ensure that the mains
(power) switch shall remain
readily operable.
The standby button " "
is located just below the
2B)
power switch. A red light will
indicate when the unit is in
standby mode.
The volume of the sound effects
may be adjusted up or down
by pressing the volume control
buttons (
(Figure 2)
Figure 2C & 2D
www.dimplex.com
(Figure
).