Electrical Connection - ROSIERES RVM 324 Instrucciones De Empleo E Instalación

INSTALLATION – ELECTRICAL CONNECTION
The operational setting up of household appliances in their environment is a
delicate operation that, if not done correctly, can have serious consequences for
consumer safety.
Therefore, this work must be entrusted to a professional who can carry it out in
compliance with the technical standards in force.
However, if despite this recommendation, the consumer carries out the
installation themself, the ROSIERES will not accept any responsibility in case of
technical failure of the product whether or not it causes damage to goods
and/or persons.
«The installation receiving the appliance referred to must comply with the standard in
force in the installation country».
The ROSIERES does not accept any responsibility if this provision is not complied with.
Caution:
• Before connecting, check the power supply voltage shown on the meter, the circuit
breaker setting, the fuse rating and the earth continuity of the installation.
• The electrical connection to the mains must use an earthed socket outlet, or pass
through an all-pole cutting device having a minimum contact opening distance of
3 mm.
If the appliance has a socket outlet, it must be installed so that the socket outlet is
accessible.
• The green/yellow protection wire must be linked to the earth terminals, of the
appliance on one side, and the installation on the other side.
• We cannot be held responsible for any incident or its consequences that may arise
during the use of an appliance not linked to the earth, or linked to an earth whose
continuity is defective.
• All work in relation to the power supply cable must be carried out by the after sales
service or someone with similar qualifications.
The hob is fitted with a power supply cord which allows it to be connected only
to a power supply of 220-240 V between phases or between phase and neutral.
• Connect to a socket, to choose the correct fuse, you must refer on the
table on page 28 or 29.
It is however possible to connect the hob to :
. Three phase
. Three phase
26 -
220-240 V3~
380-415 V3N~