Preliminary Warnings; Safety Warnings - GET JUMPSTARTER MINI Guia

ENGLISH
A. PRELIMINARY WARNINGS
Check the charge status of the device. If it is under 50% (2 LEDs out of 4),
JumpStarter needs to be recharged. To keep the JumpStarter energy capacity
constant, it should never be completely discharged for more than 30 days.
Beyond this term, the device may partially or totally lose its functionality.
If JumpStarter emits an acoustic signal during the start attempt, this means
that the device is in protection mode, not allowing further attempts.
Please, recharge the device before trying again.
It is recommended not to perform further restart attempts before recharging,
otherwise JumpStarter may fall below the minimum capacity threshold. In this
case the device could not be charged again anymore.
Please, connect only the clamps included in the package.
Caution: Using ports or harnesses other than those included in the
JumpStarter package can damage – partially or totally – both the device
and what is connected to it.
B. SAFETY WARNINGS
Before using GET JumpStarter Mini, please read all instructions, safety
warnings and precautions carefully, for working and maintenance procedures,
for the list of components and for technical specifications. Failure to do so
may lead to incorrect operation or device malfunctions, resulting in damage to
the product or personal injury.
The following safety notes are extremely important to ensure the user's
safety and to avoid damages to the device or to any product linked to it.
1. This device has been designed and tested only and exclusively for starting
12V up to 2000cc vehicles (not suitable for Diesel vehicles). Don't use this
device to start other vehicles. It is also a Power Bank and a torch light. Do not
use it for any other purposes
2. Keep it away from children, persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge.
3. Improper use of the battery charger or tampering with the built-in electronic
circuit will invalidate your warranty.
4. The appliance must be repaired or serviced by trained personnel only.
EN
2