Gerreka NAOS Guía Rápida De Instalación Y Programación página 11

NAOS
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. You can download the installation manual in the
WARNING
"Downloads" section of the Erreka website:
http://www.erreka-automation.com
Unlocking
Manual operation unlocking: pull the knob or cable
(1) until the release lever (2) is vertical.
Motorised operation locking: place the lever in
horizontal position (3). Locking will take place when the
operator starts up.
Elements of the complete installation
3
D260C
Assembly levels
Level H: the track should remain 10
cm above the highest point of the
door (see detail H ).
Total length (operator + guide) and
effective travel:
– track ref. ANA01; pos J :
3502 mm / 2741 mm
– track ref. ANA01; pos K :
3452mm / 2,691mm
– track ref. ANA02; pos J :
4602mm / 3,841mm
– track ref. ANA02; pos K :
4552mm / 3,791mm
Electrical wiring
A: Main power supply
B: Closing photocells
C: Pushbutton/wall key
D: LUMI flashing light
I260B
Electrical connections

Disconnect the power supply before connecting
or disconnecting any component.

A.T., S and STOP devices must be voltage-free in
order to prevent any damage to the control board.
A.T. Wall key or button
S Closing safety device (closing photocell)
AUX Power supply for peripherals (24 Vdc)
STOP Emergency shutdown
LAMP Warning light (24 Vdc)
Battery connection using sp+ and sp- wire
connectors (inside the frame). Charger CHG01 is
required (included in kit ADO01 with 12V 1.2Ah
batteries).
English
P260M
11