Parameter Programming - Gerreka NAOS Guía Rápida De Instalación Y Programación

6 Install the central support (9).

THE OPENING STOPPER MUST BE CORRECTLY INSTALLED (10), as the carriage must come up
against it when programming the travel. If this is not the case, the operation will not be
programmed correctly.
Ensure that the
operator is
programmed to
store the type of
transmitter to be
used: fixed code (F),
standard roller code Press CODE for at least 2 seconds. F,
(r) or personalised r or r. lights up in accordance with
(r.) (see "STEP 6" on
the type of transmitter to be
programmed.
page 14).

Keep SET
pressed
down until
1 appears.
Release SET
1
STEP
Store door
open
position
Radio code programming
The memory can store up to 20 different codes. To completely delete the memory, press CODE
for 5 seconds.All transmitters are deleted.

Parameter programming


Programming is only accessible with the door shut-down. It is not accessible
with the door opening, closing or timed to close.

During programming, the operator does not start any operation.
Press SET to save the position

When recording open door position, IT IS ESSENTIAL TO OPEN THE DOOR
UNTIL THE CARRIAGE STOPS AGAINST THE OPENING STOPPER (10).
If this is not the case, the operation will not be programmed correctly.
7 Open the door and install the opening stopper
(10) until it comes up against the carriage (11). Use
two self-drilling, self-tapping screws.
Release CODE and press the button of the transmitter to be
programmed again.
The display flashes and the operator buzzes to confirm
programming.
M260A1

Open the door through to the
opening stopper using |+ / |-

H260A
13