Connections - Axxess CHTO-02 Instrucciones De Instalación

From the 16-pin harness to the aftermarket radio, connect the:
• Red wire to the accessory wire.
• Blue/White wire to the amp turn on wire.
• Gray wire to the front right positive speaker output.
• Gray/Black wire to the front right negative speaker output.
• White wire to the front left positive speaker output.
• White/Black wire to the front left negative speaker output.
• Purple wire to the rear right positive speaker output.
• Purple/Black wire to the rear right negative speaker output.
• Green wire to the rear left positive speaker output.
• Green/Black wire to the rear left negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Blue/Pink wire to the VSS/speed sense wire.
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire
• Tape off and disregard the following (2) wires, they will not be used in this application:
Brown, Orange/White
2

CONNECTIONS

From the CHTO-02 harness to the aftermarket radio, connect the:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Orange wire to the illumination wire (if applicable).
12-pin ASWC-1 harness & 3.5mm jack:
• The 12-pin ASWC-1 harness & 3.5mm jack is to be used with the ASWC-1 (sold separately) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard this harness.
If it is to be used, refer to the ASWC-1 instructions for radio connections and programming.
Disregard the harness that comes with the ASWC-1.