Xylem PolluStat Manual De Instalación Y De Instrucciones página 104

Plug the interface module on the right side of the PC board (see picture 3). The cables are to be fed through the rightmost
cable feedthroughs into the calculator after removing the blind grommets. Close the calculator.
Protect the calculator against unauthorized opening using one of the numbered adhesive seals enclosed to the modules (stick it
upon the seal destroyed). The added bar code label can be used for the purpose of documentation.
To remove a module the upper housing piece must be carefully pressed against the rear panel of the lower housing piece
during opening the calculator. Thus the two rear snap-fits of the upper housing piece lever out the module of the PC board (see
picture 4).
Page 104 of 108 Article no.: 1080619046 2020_07_27 Subject to technical change! Errors excepted.