Metra CHTO-02 Instrucciones De Instalación página 3

Connections to be made
• Connect the green/Purple wire to the reverse wire of the aftermarket
navigation radio.
• Plug the 16-pin harness into the CHTO-02.
From the 22-pin Chrysler harness:
• Connect the yellow wire to the radio's 12-volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the orange wire to the illumination wire of the aftermarket radio. If the
aftermarket radio has no illumination wire just tape off the orange wire.
• Plug the 14-pin harness into the CHTO-02.
The 12-pin harness (ASWC plug) will be discussed later in the manual.
Installing the CHTO-02
• With all connections completed to the aftermarket radio, plug the 22-pin
harness into the vehicles wiring harness.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then "off" and "on"
again to test the radio.
CHTO-02
Testing the CHTO-02
• Turn the ignition on if not already, and then
turn the radio "on" to verify that the radio
works. Check balance and fader controls for
proper operation.
• To adjust the overall volume of your
audio system, rotate the potentiometer
which is located on the 16-pin side of the
interface clockwise.
Additional 12-pin harness
This 12-pin harness is to be used in conjunction with the ASWC (not included).
Please refer to ASWC instructions for programming.
3
Potentiometer
(ASWC harness)