Maintenance And Cleaning; Declaration Of Conformity - Würth PL 07 Instrucciones Para El Manejo

PL07.book Seite 9 Freitag, 5. Oktober 2007 9:50 09
Projecting 90° angles
Set up the unit close to the reference object
and adjust a laser beam parallel to it. Align
the object subject to aligning (e.g. a rail)
parallel to the 90° laser beam.
Maintenance and
Cleaning
Clean the laser exit windows with a soft cloth.
If this is not sufficient, use cleaning alcohol and
a cotton cloth. Keep and store the unit in its
case. Remove the batteries when not using for
extended periods.
Do not use aggressive cleaning agents or
solvents.
If the machine should happen to fail despite the
care taken in manufacture and testing, repair
should be carried out by an authorized custo-
mer service agent for Würth power tools.
For all correspondence and spare parts orders,
always include the article number on the type
plate of the machine.
Disposal
Power tools, accessories and pa-
ckaging should be sorted for envi-
ronmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household was-
te!
According to the European Directive 2002/96/EC
on waste electrical and electronic equipment and its
incorporation into national law, power tools that
are no longer suitable for use must be separately
collected and sent for recovery in an environmen-
tal-friendly manner
Battery packs/batteries:
Do not dispose of battery packs/batteries into
household waste, water or fire. Battery packs /
batteries must be collected, recycled or dis-
posed of in an environmentally-friendly way.
Only for EC countries:
Defective or dead batteries must be recycled
according to the directive 91/157/EEC.
For this Würth tool, we provide a warranty in
accordance with statutory/country-specific re-
gulations from the date of purchase (proof of
purchase by invoice or delivery note). Damage
that has occurred will be corrected by replace-
ment or repair.
Damage caused by normal wear, overloading
or improper handling is excluded from the
warranty.
Claims can be recognised only when the tool is
presented undisassembled to a Würth branch
office or a Würth field service employee.
We declare under our sole responsibility that
this product is in conformity with the following
standards or standardization documents:
EN 61 000-6-1
EN 61 000-6-3 (EN 50 081-1), IEC 60 825-1
according to the provisions of the regulations
89/336/EEC.
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Warranty
Declaration of Con-
formity
07
R. Bauer
(EN 50 082-1),
9