Replacing The Uv-C Lamp - Laguna PT1671 Guia De Funcionamiento Y De Mantenimiento

Removing the quartz sleeve
Step 1 Unscrew the 4 stainless steel screws and pull out the square piece that
contains the quartz sleeve. May require a bit of force to pull out. Tip - use
a magnetic screw driver (fig 4, 5, 6).
Step 2 Check to ensure quartz sleeve is undamaged.
Step 3 Clean the quartz sleeve and polish with a soft cloth or paper towel. In
case of stubborn dirt or lime scale, some vinegar may be used. Do not
use detergents or other chemical cleaners. Avoid touching with bare
hands (fig 7).
Step 4 Make sure that internal parts of the appliance are dry before, during and
after the maintenance operations.
Replacing the quartz sleeve
Step 1 Reposition the quartz sleeve by lining up the pin found on unit to the hole
on the plastic end of the quartz sleeve (fig 8).
Hole
4
Step 2 Once properly in place, fasten all 4 screws with the screw driver (fig 9).
5

Replacing the UV-C lamp

Step 1 Holding the new UV-C lamp with a cloth, carefully insert the 4 prongs into
their socket – be sure to align the prongs properly. Ensure that the lamp
seal is properly in place (see fig. 10) Do not touch UV-C lamp with bare
hands (fig 10).
6
Step 2 Reposition the UV enclosure and tighten the locking screw
(fig 11, 12).
7
Pin
11
8
9
10
12
5