EIBENSTOCK SS 1401 L Manual Original página 17

Translation of the original instructions from German.
Important safety instructions
Before using the vacuum cleaner, always read the operating instructions and keep them readily avail-
able.
Purpose and intended use
Besides the operating instructions and the binding accident prevention regulations valid in the country
of use, observe recognised regulations for safety and proper use.
The appliance must
– only be used by persons, who have been instructed in its correct usage and explicitly commis-
sioned with the task of operating it
– only be operated under supervision
The appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge.
Children should be supervised to ensure that they do not play with the appliance.
The vacuum cleaner is equipped with a socket that can be used to connect electric tools. The vacuum
cleaner is switched on and off with the electric tools connected. Use the socket on the vacuum cleaner
for the purpose defined in the operating instructions only.
Maximum permitted power consumption of the electric tools to be connected: see section „Technical
Data".
The vacuum cleaners described in this operating manual are suitable for
– extracting in conjunction with electric tools that generate dust
– sucking up dust and liquids
– commercial use, e.g. on construction sites, in hotels, schools, hospitals, factories, shops, offices
and rental businesses.
– separation of dust with an exposure limit of greater than 1 mg/m³, (dust class L). Please observe
regulations valid in your country.
The following materials should not be picked up by the vacuum cleaner
– hot materials (burning cigarettes, hot ash, etc.)
– flammable, explosive, aggressive liquids (e.g. petrol, solvents, acids, alkalis, etc.)
– flammable, explosive dust (e.g. magnesium dust, etc.)
The appliance must
– be operated indoors, operated outdoors only for short periods
– be protected against UV radiation
Before start-up
Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power
supply. It is recommended that the vacuum cleaner should be connected via a residual current circuit
breaker.
Inspect power cord regularly to detect signs of damage, e.g. cracks or ageing. If the power cord is
damaged, it must be replaced by Eibenstock-Service or an electrician to avoid danger before use of
the vacuum cleaner is continued. Use only the type of power cord specified in the operating manual.
D
Eibenstock SS 1401 L
GB
F
E
I
NL
DK
PL
RUS
GR
TR
17