Parts Identification - Panasonic EW1311 Manual De Instrucciones

Parts identification

Front Back








 
A Main unit
1 Nozzle release button
2 Power switch
3 Mode switch
4 Mode indicator
5 Charging indicator
6 Ventilation hole
7 Suction hose
8 Filter
9 Water tank
 Water tank cap
B Charger (RE8-47/RE8-53)
(The shape of the power
plug differs depending
on the area.)
 Charging section
10
EW1311_EU.indb 10






   

 Cord
 Power plug
> Nozzle stands
? Screw holes for wall
mounting
The charger can be
mounted on a wall
using two wood screws.
C Nozzle (x4)
@ Nozzle
A Identification ring
B Nozzle handle
Accessories
D 2 screws
Note
There may be moisture inside the main unit (water
tank and suction hose) left from the distilled water
used for product testing.
Charging
► On the bathroom countertop or a shelf
1. Place the cord in the right, left or
centre cord guide, depending on
where the charger will be placed.
2. Place the charger on a secure, level
surface.
3. Plug in the power plug.
1
1
Insert main unit so it stands
upright in the charging section.
The charging indicator will light up.
• Be sure to place the main unit
upright. If the main unit is tilted or not
in direct contact with the charger, the
main unit may not charge properly.
• Charging is completed in about 15
hours.
• The lamp does not go off even
when charging ends.
• The main unit will provide an operation
time of approximately 15 minutes of
use when the battery is fully charged.
(The operating duration will become
shorter as the batteries get older.)
2018/11/14 13:02:24