SSS Siedle BCM 653-0 Informacion De Producto página 6

English
Application
Wide­angle camera with a 130° or
180° angle of aperture, mounted in
Siedle Classic. Infrared lighting and
heating integrated.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
In the case of video systems, the fol­
lowing mounting situation must be
avoided at all costs:
• direct ajour light
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Mounting
1 Recommended mounting height
appr. 1.60 m to centre camera.
2 Note the mounting position of the
camera, the type designation must
be legible at the top back of the
module.
3 Pick­up angle of the camera with
an angle of aperture of 130°
4 Pick­up angle of the camera with
an angle of aperture of 180° in the
full screen mode.
5 With an angle of aperture of 180°,
the pick­up angle of the camera
can be adjusted to any mounting
situation. Open the flap on the back
of the module with the aid of a
screwdriver.
6 Set the required picture excerpt
(1 to 9) or full screen (0) using the
rotary switch. Once the required pic­
ture excerpt has been set, close the
flap and mount the module.
6
7 Select the picture excerpt based
on the existing mounting situation.
a Picture excerpt (1­3) top camera
alignment
b Picture excerpt (4­6) central
camera alignment
c Picture excerpt (7­9) bottom
camera alignment
Terminal assignment
BCM 653-.../BCM 658-...
TaK In­Home bus: Video,
TbK camera branch
Ta Connection of the
Tb BTLM/BTLE door loudspeaker
Vc Actuation from the door
GND loudspeaker to turn the
camera on
b 12 V AC supply
c for heating
ACM 673-.../ACM 678-...
V1 video signal
V2 (two­wire FBAS)
V3 camera supply
V4
V5 Actuation of
V6 video output
CM 613-.../CM 618-...
+M Supply voltage Video
­M 20–30 V DC
Vc Actuation from door loud­
­ speaker for camera on
VKA Actuation of camera
distributor –M is switched
A1 Potential­free contact for
A1 additional applications
b Power supply 12 V AC
c for heating
Coaxial cable
L conductor
S shield
Installation
Installation and commissioning are
described in the relevant system
manual.