Connecting Drain Hose - LG WFS1918EKD El Manual Del Propietario

30
C
onnecting Drain Hose
Before connecting Drain Hose, check your Drain Hose model and choose the correct
instructions.
Pump Model
Insert the plastic holder into hole
in the back side toward the stand
pipe direction. Adjust the holder
by pressing the both sides to
push in.
Push the end part of the drain hose in the
outlet of the drain pump and tighten with
2
the clamp to fit in.
Put the other end of the drain hose over the
standpipe or wash tub. To prevent the hose that
3
is connected with pump hanging down, push the
hose into the holder to fix.
Caution
• The outlet should be placed 0.9~1.2m higher than the floor.
• To prevent siphon, the drain hose should not be extended more
than 50mm from the end of the hose guide.
• The hanging down drain hose might cause poor drainage.
Non-Pump Model
Ensure that the hose clip is set as indicated here.
Before connecting
2
Push the elbow hose toward the body of the
Connect the Elbow Hose
washing machine.
3
To change the direction of the hose, pull out the
Place the Drain Hose
elbow hose and change the direction.
Repeat Step 2.
Holes
For Holder
Holes
Bottom
For Holder
Holes
Bottom
For Holder
Holes
For Holder
Within 50mm
0.9~1.2m
Within 50mm
Hose
Guide
Within 50mm
0.9~1.2m
Hose
Guide
0.9~1.2m
Within 50mm
0.9~1.2m
Bottom
Bottom
Hose
Guide
Clip
Hose
Guide