Kohler K-14616 Guia De Instalacion página 4

Ocultar thumbs Ver también para K-14616:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lift Rod Hole
Connecting Nut
Mounting Stud
Washer (Replace
With Escutcheon
Washer If
Escutcheon Is
Used)
Hose
2. Install the Faucet
For All Lavatories
Flush the water supply lines thoroughly to remove debris.
Slide the washer (or escutcheon washer is escutcheon is used)
over the flexible hoses and mounting stud and into the groove in
the faucet body.
Insert the flexible hoses into the deck. Angle the mounting stud
so the connecting nut fits through the hole.
Center the washer and faucet over the hole.
Insert the supplied hex wrench into the lift rod hole. Tighten the
nut inside until the faucet is firmly held in place.
Check to be sure the nut is centered and the flexible hoses hang
freely.
Remove excess putty from escutcheon, if installed.
Attach the hoses to the water supplies. When facing the front of
the faucet, the left hose is hot water, the right hose is cold water.
Lift the faucet handle. Turn the handle left for hot water, right for
cold water or to the center for warm water.
1002277-2-C
Hex
Wrench
Connecting
Nut
4
Mounting
Stud
Hose
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-14616-414616-4-cp

Tabla de contenido