Connections On The Back; Connecting The Monitor; Connect Signal Cable; Connect Audio Cable - Medion AKOYA E54005 Manual De Instrucciones

Connections on the back

Power supply (POWER IN)
1.
3.5 mm stereo jack audio connection (AUDIO IN)
2.
Mini 15-pin D-sub connection (VGA)
3.
Intake device for protection against theft (Kensington lock)
4.

Connecting the monitor

 Ensure that the TFT monitor has not yet been connected to the electricity supply (mains plug not yet
plugged in) and that neither the TFT monitor nor the computer has been switched on.
 Prepare your computer for the TFT monitor if necessary, so that the correct settings for it will be present.

1 Connect signal cable

 Plug the signal cable into the VGA connection on the computer and the TFT monitor.

2 Connect audio cable

 Plug the audio cable into the appropriate audio sockets on the computer and the TFT monitor.

3 Connect the power supply

 Now connect one end of the mains cable supplied with the device to TFT power supply connection and
then the other end to an appropriate socket. The mains socket must be in the vicinity of the TFT monitor
and be easily accessible (use the same electricity circuit as for the PC).

4 Switch on the monitor

 Switch your monitor on at the Standby/On switch on the front of the device. Finally, switch your computer on.
10
(Ill.: Rear of the monitor)
Bringing the device into operation