Repair; Caution! Pay Attention To The Surrounding Temperature; Warning! Pay Attention To Safety During The Connection; Power Supply - Medion MD Business P54017 Manual De Instrucciones

Repair

 Leave the repair of your TFT monitor exclusively to qualified specialist personnel.
 Please contact our authorised Service Partners exclusively in the case of a necessary repair.

Caution! Pay attention to the surrounding temperature!

 The TFT monitor can be operated at a surrounding temperature from 0° C to +35° C and at a relative
ambient moisture level of < 80% (non-condensing).
 The TFT monitor can be stored at -20° C to +60° C when it has been turned off.
Danger! Pay attention to the following:
Wait to bring the device into operation until it has reached the surrounding temperature,
after the TFT monitor has been transported.
Moisture, which can cause an electrical short-circuit, can form within the TFT monitor in
the case of wide variations in temperature or moisture.

Warning! Pay attention to safety during the connection!

Power supply

Please pay attention: Parts of the device will be subject to voltage, even if the mains switch has
been switched off. Pull the mains plug from the socket, to interrupt the power supply to your TFT
monitor or to release the device from voltage completely.
 Only operate the TFT monitor at an earthed socket with 100-240V~, 50/60 Hz. Ask your energy supplier if
you are not sure about the power supply at the set-up location.
 We recommend the use of protection against excess voltage for additional safety, in order to protect your
TFT monitor against damage because of voltage peaks or electrical flashes on the mains network.
 Pull the power pack from the socket, to interrupt the electricity supply to your device. Always hold the
power pack firmly when pulling out the cable. Never pull the line.
 The socket must be located close to the TFT monitor and be easily accessible.
 Lay the cable so that no-one can tread on it or trip over it.
 Do not place any objects on the cable, because it could be damaged otherwise.
 Your device features an on-/off switch to power the TFT-display on or off. If the switch is set in the OFF
position, no power is consumed. Put the on-/off switch to the OFF position or use a master-slave-power
strip to avoid power consumption when the device is switched off.
 Maintain at least one metre clearance from high frequency and magnetic sources of interference
(television device, loudspeakers, mobile phone, cell phone, etc.), in order to avoid disruptions to function
and data loss.

Information about conformity

The TFT monitor fulfils electromagnetic compatibility and electricity safety requirements.
Your device complies with the European Norm ISO 9241-307 Class II (Pixel error class) (see P. 17).
Your device complies with the basic requirements and the relevant guidelines of the 2004/108/EU EMV Guidelines
[electromagnetic compatibility] and the 2006/95/EU Guideline for low voltage devices.
This device fulfils the basis requirements and the relevant regulation of the Ecodesign Guideline 2009/125/EG
(Commission Regulation 1275/2008).
4
English