Wall Mounting; Manual Control - Pur Line HOTI M52 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
OpERATION INSTRUCTIONS

WALL MOUNTINg

Install the appliance at 1.80 m. above the ground.
Place the screws and make sure they are steadily attached to the wall before mounting the appliance.
USE
Turn off all control buttons on the appliance. Then put the plug into a standard earthed socket with AC supply. Make
sure the plug is steadily inserted into the socket.
The heater is fitted with an overheating protection system that turns off the appliance when its parts become too hot.
Insert the plug in the wall socket and the power indicator light will turn on.
The appliance can be controlled manually or through a remote control. The remote control uses two AAA batteries
(not included in the appliance set), place them under the rear lid as you watch out for the poles position, then press
and direct the transmitter of the remote control towards the appliance. lf the appliance does not respond, probably
the batteries need to be changed.

MANUAL CONTROL

- Press the "ON/OFF" button on the control panel
once and the heater will function as a fan, blowing
cool air only and the COOLAIR indicator light will
be on.
- Press the "ON/OFF" button twice and the appliance
will start heating at a 1000W power level, the
respective indicator light will turn on.
- Press the "ON/OFF" button third time and the
appliance will start heating at a 2000W power level,
the respective indicator light will turn on.
- By pressing the "ON/OFF" button for the 4th time
you will turn the appliance off but it will cool itself
for another minute. The light indicator will turn off afterwards.
SETTINg AND REgULATION WITH THE REMOTE CONTROL
- Press the "ON/OFF" button on the control panel and the heater will function as a fan, blowing cool air
only. The COOLAIR indicator light will be on.
Press the 1000W button to set to half power - 1000W.
Press the 2000W button to set to full power - 2000W.
- By pressing the "TIMER" button you can set the appliance to turn itself off in 1 hour or up to 7 hours.
The remote control has a range of about 5 m.
- Press the "ON/OFF" button to turn off the appliance. The light indicators will go down.
FAN
ON/OFF
1h
TIMER
6
1000W
2000W
2h
4h
HIGH
LOW
TIMER

Publicidad

Tabla de contenido
loading

Tabla de contenido