General Information - Gaggenau AA200882 Instrucciones De Montaje

WARNUNG ‒ Verletzungsgefahr!
Der Geruchsfilter bleibt nach dem Regenerieren lan-
ge Zeit heiß.
Den Geruchsfilter direkt nach dem Regenerieren
▶
nicht berühren, sondern abkühlen lassen.
Hinweis: Beim Regenerierungsprozess können sich
Teile des Geruchsfilters verfärben. Die Verfärbungen
haben keinen Einfluss auf die Funktion des Geruchs-
filters.
Voraussetzung: Der Geruchsfilter ist ausgebaut.
Den Backofen auf maximal 200 °C (Umluft )
1.
vorheizen.
Um das Backblech nicht zu zerkratzen, den Ge-
2.
ruchsfilter auf einen Rost legen.
Während des Regenerierens kann es zu einer Ge-
3.
ruchsentwicklung kommen. Um sicherzustellen,
dass der Raum gut belüftet ist, ein Fenster öffnen.
Den regenerativen Geruchsfilter mit den folgenden
4.
Einstellungen regenerieren.
Dauer Temperatur
120 min max. 200 °C
Den heißen Geruchsfilter auf einer hitzebeständi-
5.
gen Unterlage abkühlen lassen.
en

General information

¡ Read this instruction manual carefully.
¡ Keep the instruction manual and the
product information safe for future refer-
ence or for the next owner.
¡ The appliance can only be used safely if it
is correctly installed according to the
safety instructions. The installer is re-
sponsible for ensuring that the appliance
works perfectly at its installation location.
¡ This instruction manual is intended for the
installer of the optional accessory.
¡ Only a licensed expert may connect the
appliance.
¡ Switch off the power supply before carry-
ing out any work.
Safe installation
Observe the safety instructions when installing the
optional accessory.
WARNING ‒ Risk of suffocation!
Children may put packaging material over their
heads or wrap themselves up in it and suffocate.
Keep packaging material away from children.
▶
Do not let children play with packaging material.
▶
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
The odour filter remains hot for quite some time after
it has been regenerated.
Do not touch the odour filter straight after it has
▶
been regenerated – allow it to cool down.
Included with the appliance
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
→ Fig.
1
Establishing the pipework
1.
2.
Fitting odour filters
1.
a The glass panel moves up to halfway upwards
2.
3.
Heizart
4.
Umluft
5.
a The glass panel and the filter cartridges move
a The appliance flap closes and the appliance
Cleaning the odour filter
ATTENTION!
Incorrect cleaning damages the regenerative odour
filter.
▶
▶
▶
Regenerating the odour filter
The oven cleaning function (pyrolytic self-clean) may
cause a regenerable odour filter to catch fire.
▶
The odour filter remains hot for quite some time after
it has been regenerated.
▶
Note: During the regeneration process, parts of the
odour filter may become discoloured. This discolour-
ation has no effect on the performance of the odour
filter.
Requirement: The odour filter is removed.
1.
2.
3.
4.
Establish the pipework in such a way that the flex-
ible hose is flush with the cabinet base.
→ Fig.
2
For circulating-air mode, establish an air outlet in
the unit's front toe kick.
The air outlet must have a minimum cross section
of approximately 400 cm². Make the outlet open-
ing in the base panel as large as possible in order
to keep draughts and noise to a minimum.
Press ⁠ .
and grease filter cassettes are transported up-
wards.
Remove the grease filter cassettes.
→ Fig.
3
Insert the odour filter cartridges.
→ Fig.
4
Insert the grease filter cartridges.
→ Fig.
5
Press ⁠ .
downwards.
switches off.
Observe the regeneration instructions.
Never clean a regenerative odour filter with clean-
ing products, water, in the dishwasher or with a
wet cloth.
If the regenerative odour filters are visibly soiled,
remove the dirt with a damp cloth before starting
the regeneration process.
Ensure that the odour filter does not get wet.
WARNING ‒ Risk of fire!
Never regenerate a regenerable odour filter with
the oven cleaning function (pyrolytic self-clean).
WARNING ‒ Risk of injury!
Do not touch the odour filter straight after it has
been regenerated – allow it to cool down.
Preheat the oven to a maximum of 200 °C (air re-
circulation ).
To ensure that you do not scratch the baking tray,
place the odour filter on a wire rack.
During regeneration, an odour may develop. Open
a window to ensure that the room is well ventil-
ated.
Regenerate the regenerative odour filter with the
following settings.
3