Dometic GROUP WAECO CoolAir RT880 Instrucciones De Instalación página 36

Installation
➤ Position the spacer sleeve (fig. 6 1, page 5) on the fixing drill holes
as shown in fig. 6, page 5.
– RT880 lveco Stralis AS/AT: spacer sleeve L = 18 mm
– RT880 lveco Stralis AS³: spacer sleeve L= 40 mm
➤ Screw one hex screw (fig. 6 4, page 5) with washer (fig. 6 2,
page 5) and spring washer (fig. 6 3, page 5) into each of the 12
thread inserts on the underside of the unit.
– RT880 lveco Stralis AS/AT: hex screw M8 x 45
– RT880 lveco Stralis AS³: hex screw M8 x 65
A
NOTICE!
Do not exceed the specified torque under any circumstances. This is the
only way to ensure that the thread inserts are not torn out.
➤ Tighten the screws with a torque of 8 Nm.
36
CoolAir RT880
EN