Publicidad
Step 6
Separate the EXTENSION SLIDES (FF) from the EXTENSION RAILS (EE)
å
as shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (EE) to the ENDS (A and B) and
å
UPRIGHTS (C and D). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL out to fi nd the other hole that lines up with the hole in the ENDS and
UPRIGHTS. Turn a SCREW into this hole.
C
Open end
www.sauder.com/services
FF
Push the black lever in and pull the SLIDE from the RAIL.
A
EE
B
EE
Open end
EE
D
418795
EE
Open end
Open end
EE
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Page 11
Publicidad
