Moving The Wet/Dry Vac; Blowing Feature - RIDGID WD7000 Manual Del Operador

SP6659-3 WD7000 ES.qxd
Operation (continued)
4. Dump the drum contents into the
proper waste disposal container.
5. Replace the drum by reinserting into
the cavity and push until it snaps into
place.

Moving the Wet/Dry Vac

To maneuver the vac, the metal handle in
the rear of the unit should be positioned
in the upright position for ease of
movement. Be sure to unlock the back
wheels by pulling up on the wheel locks
before moving the vac.

Blowing Feature

Your vac features a blowing port. It can
blow sawdust and other debris. Follow
the steps below to use your vac as a
blower.
WARNING: Always wear safety
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
! WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
! CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
!
hearing damage wear ear protectors
when using the vac/blower for
extended hours or when using in a
noisy area.
1. Locate blowing port of your vac.
2. Insert the locking end of the hose
assembly into the blowing port of the
vac. The hose should snap into place.
To remove the hose from the vac,
press the release button in the hose
assembly and pull the hose out of the
vac inlet.
3/26/08 9:44 AM Page 12
3. (Optional) Attach extension handle to
opposite end of hose, then place the
crevice tool on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
12
Pull Up to Unlock
Wheel Locks
Locking End
Hose
Assembly
Blowing Port