Cord Maintenance; Moving The Wet/Dry Vac; Blowing Feature - RIDGID WD1250 Manual Del Propietário

All manuals and user guides at all-guides.com
SP6663 12 GALLON.qxd 3/16/07
5. Dump the drum contents into the
proper waste disposal container.
! WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the vac light enough to lift
comfortably.

Cord Maintenance

When vacuuming is complete, unplug the
cord and wrap it around the motor cover.

Moving the Wet/Dry Vac

Should it become necessary to pick the
vac up to move it, the handles on the
sides of the dust drum are used to lift. To
maneuver the vac, the pull handle above
the inlet should be used.

Blowing Feature

Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the steps below to use your vac
as a blower.
! WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
! WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
! CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
!
hearing damage wear ear protectors
when using the vac/blower for
extended hours or when using in a
noisy area.
8:57 AM Page 9
1. Locate blowing port of your Wet/Dry
Vac.
2. Insert Tug-A-Long end of hose into the
blowing port of the vac.
3. (Optional) Attach extension wand to
swivel end of hose, then place a car
nozzle on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
Tug-A-Long
Hose
Extension
Wand
(optional)
9
Blowing
Port
Swivel
End of
Hose
Car
Nozzle
(optional)