Kärcher 2.643-381.0 KM Medium Manual Del Usuario página 13

3.6 Securing the fleet management module on the holder
Figure 8
3.7 Attaching the antenna to the fleet management module casing
Figure 9: Antenna cable
Figure 10: Completely installed and connected fleet man-
agement module
Position the Fleet Management module on the tin plate.

Screw in M4x6 screws and tighten them.

Max. torque 1 Nm.
1 Cable connector
Coil the antenna cable as shown and secure it with ca-

ble ties.
1 24-pin plug
2 Antenna
3 Adhesive pad, double sided
4 Fleet Management module
5 GPS plug, blue
6 COMM plug, purple
Degrease the glued surface on the antenna and the

Fleet Management module with the supplied cleaning
cloth.
Attached the adhesive pad at the centre of the anten-

na's bottom side.
Note
The bottom side is opposite of the side with the label
"FACE TO SATELLITE"
Turn the antenna with the label "FACE TO SATELLITE"

so that it faces upwards.
Glue the antenna onto the fleet management module

as shown; type plate and marking of the LEDs must still
be readable.
Insert the antenna plug into the Fleet Management

module. Connect the plug and socket of the same
color.
Fasten the antenna cable to the holder using a cable

tie.
Insert the 24-pin plug of the supplied cable harness into

the Fleet Management module.
5
-
EN 13