Bose S1 Pro Guia De Inicio Rapido página 2

oméstico y
reciclado.
aturales,
de la
dad local, un
Installation Instructions
This optional battery is for use when AC power is not readily available.
1.
2.
3.
ción de CA.
uentra en la 4.
Vea la figura
Sleep Mode
den alineadas
Your S1 Pro battery accessory will be shipped in Sleep mode. Your battery will be
unusable until woken from Sleep mode. To wake your battery from Sleep mode, plug
fuerce la
your S1 Pro into AC power and switch your S1 Pro to On ( ) after proper installation
er a intentar
(see "Installation Instructions" above).
Note: Your battery will return to Sleep mode if not used for 30 consecutive days.
6 y la figura 7.
Charging the Battery
odrá usar
ón, enchufe
ma S1 Pro a
Anytime your S1 Pro is plugged into AC power and the system is not in use, the battery
cciones de
is charging.
Quick Charge
e cargarla
Though the battery will always charge while your S1 Pro is connected to AC power, Quick
Charge enables you to charge your battery more quickly. To enable Quick Charge, place
the power switch into the downward position (
Battery Life Indicator
que no se
The current state of the battery life
is shown by the power LED indicator
(see Figure 8), which will flash when
the unit is powered on. You can also
check the battery life by double-
una fuente
clicking the Bluetooth® button, which
Para
will cause the power LED to flash.
ndo no use
See the following table for charge
indicators:
Note: The LED indicator will flash red
when below 10% charge.
Note: A sticker depicting the above
table is included with your battery
pack. For easy reference, it is recommended that you apply this sticker to the bottom
plate of your S1 Pro system.
Additional Information
For more information on the Bose® S1
Pro Multi-Position PA system, refer to
the owner's guide available at
www.Bose.com. To request a printed
copy, use the phone numbers provided.
The Bluetooth® word mark and logos
are registered trademarks owned by
Unplug the S1 Pro and make sure the power is switched to Standby (
Turn S1 Pro upside down; unscrew two screws and remove bottom plate. See
Figure 2 and Figure 3.
Seat battery into designated holster so connector pins line up appropriately. See
Figure 4 and Figure 5.
CAUTION: Battery should easily slide into holster. Do NOT force battery into
holster. If battery is difficult to insert, rotate 180° before trying again.
Replace bottom plate over battery and secure with two screws. See Figure 6 and Figure 7.
CAUTION: Make sure your battery is fully charged before storing for more
than 30 days.
) when not in use. See Figure 8.
Importer Information
European Union
Bose Products B.V., Gorslaan 60, 1441 RG
Purmerend, The Netherlands
China
Bose Electronics (Shanghai) Company
Limited, Part C, Plan 9, No. 353 North
Riying Road, China (Shanghai) Pilot Free
). See Figure 1.