Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Product Assemblies
SP-BSC12-2-27-P
SP-BSC15-2-35-P
Place sliding base assembly on cabinet floor,
1
in desired position. Position front mounting
strap against the back edge of the cabinet
face frame. (If installing in a frameless cabinet,
measure 1/2" to 3/4" back from front of
cabinet opening, and align sliding base
assembly parallel to cabinet opening.) Close
door to make sure the assembly will not
hold cabinet door open. Also, check to see
if unit will clear the door opening when fully
extended. Once position is determined, fasten
in place using four mounting screws provided
and a Phillips head screwdriver.
OPTIONAL STEP: Mark placement of mounting
holes with a pencil, remove sliding base
assembly and drill pilot holes for fastening
screws. Place sliding base assembly back into
position and fasten with the provided screws.
IMPORTANT: The front and rear wire cages
are different. Install the rear cage first.
Double Pullout Waste Bins
Inspect all parts and read all instructions prior to beginning assembly and installation.
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
Parts Included
Waste Bin (2)
Wire Cage (2)
1
Front
Installation Instructions
Sliding Base Assembly (1)
Mounting
Straps
Sliding Members
Handle (1)
Rear
Cage Locking Clip (2)
Mounting Screws (4)
Publicidad
Manuales relacionados para simplyput SP-BSC12-2-27-P
Resumen de contenidos para simplyput SP-BSC12-2-27-P
- Página 1 Sliding Members Wire Cage (2) Handle (1) Mounting Screws (4) Product Assemblies SP-BSC12-2-27-P SP-BSC15-2-35-P Place sliding base assembly on cabinet floor, in desired position. Position front mounting strap against the back edge of the cabinet face frame. (If installing in a frameless cabinet, measure 1/2"...
- Página 2 Install the rear wire cage first. Fully extend sliding members out of the cabinet. Place the slotted holes on the cage onto the tabs on the left hand sliding member. (2A) Rest the cage on top of the clip retainers on the right hand sliding member, but, DO NOT PUSH DOWN.
- Página 3 Soportes de alambre (2) Manija (1) Tornillos de montaje (4) Assemblages Ensamblaje de productos SP-BSC12-2-27-P SP-BSC15-2-35-P Colocar el conjunto de base deslizante en la posición deseada sobre el piso del gabinete. Poner la correa de montaje frontal contra el borde trasero del marco frontal del gabinete.
- Página 4 Instalar primero el soporte posterior. Extender completamente los brazos deslizantes fuera del gabinete. Encajar los orificios del soporte en las pestañas del brazo deslizante de la izquierda. (2A) Colocar el soporte encima de los retenedores en el brazo deslizante de la derecha, pero sin presionar hacia abajo.