simplyput SP-ECW10-1-35-W Instrucciones De Instalación

Product Assemblies
SP-ECW10-1-35-W
Place installation template on cabinet
1
floor. Drill 4 holes at locations shown on
template with 1/16" drill bit. Once the
position is determined, fasten the sliding
base assemblies to the cabinet floor by
using 2 – #8 x 1/2" mounting screws for each
slide assembly shown in image 1 below.
Tighten with a Phillips head screwdriver.
Fully extend slides out of cabinet and then
2
install 1/ea cage mounting clip bottom onto
each slide by fastening with 2 – #6 x 3/8"
cage mounting screws as shown in images
2a and 2b.
Place wire cage on top of the cage mounting
3
clip bottoms as shown in image 3 below.
Then install each cage mounting clip tops
with 2 – #6 x 3/4" cage clip screws as
shown in image 4.
With slides fully extended insert the bin
4
into the cage.
Grand Rapids, MI
800.253.1561
simplyputorganizers.com
Single Pullout Waste Bin
Inspect all parts and read all instructions prior to beginning assembly and installation.
Tools Required
• Phillips Head Screwdriver
Parts Included
Waste Bin (1)
Wire Cage (1)
1
2
b
3
WIDE
INSTALLATION
NARROW
INSTALLATION
Installation Instructions
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
Slide Assemblies (2) Cage Mounting Clips (2)
ECW-1805400CBW ECW-RSCLIP-PK
Installation Template #6 x 3/8 Large
(not shown) Mounting Screws
ECW-RSCLIP-PK
310434
NARROW INSTALLATION
USES 2 AND 4
ND TH
HOLE BACK
Knape & Vogt ® reserves the right to change specifications without notice.
• Pencil
#8 x 1/2" Mounting
Screws for Slide
Assemblies (4)
ECW-RSCLIP-PK
6 x 3/4" Cage Clip
Screws (4)
ECW-RSCLIP-PK
2
a
WIDE INSTALLATION
USES 1 ST AND 3 RD
HOLE BACK
4
©2019 Knape & Vogt. All rights reserved.
310582/REV B 1119