Datamars Speedrite 46000W Manual Del Usuario página 65

Using the energizer
Turning the energizer on
The energizer will be on as soon as it is plugged in to the mains power supply and
switched on at the wall.
Viewing the output voltage
The output voltage lights show the output voltage of the energizer. Each light segment
represents 1 kV (1000 V).
Turning the energizer off
WARNING!
In the unlikely event of a power failure, the energizer will resume
operation as soon as the power is restored. The energizer will reactivate, even if it
was in Standby mode before the power failure.
To turn off the energizer completely, while working on a section of fence:
Switch the energizer off at the wall and disconnect it from the mains power supply.
Note:
You can put the energizer into Standby mode using the remote control or the
Smartphone app. In Standby mode, the 10th LED (the last green LED) flashes:
Example: 7 lights illuminated
Voltage is between 8-9 kV (8000-9000 V)
1 2 3 4 5
Red lights Green lights
6 7 8 9 10
65