HoMedics EnviraScape Old Napoli Manual De Instrucciones E Información De Garantía página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly and Instructions for Use
Unpack the product.
Part
A
B
C
Fountain Top
D
E
F
Power Adaptor
G
Cleaning Pin
Fig. 1
Clean water
C. Fountain top
E. Light bulb
A. Base
Description
Quantity
Base
1pc
Pump
1pc
1pc
River Rocks
1 bag
Light Bulb
2pcs
1pc
1pc
G. C leaning Pin
D. River rocks
B. Pump
Switch
Cord slot
4
Attention:
To get best results, please operate pump completely submerged. Keep the water level
above the minimum water level AT ALL TIMES.
1. Place the base on a flat surface. Lead the pump cord through the cord slot on the
bottom of the base(Fig 2) This will ensure that the unit is balanced when placed on
a flat surface.
2. Insert the light bulb into the light clip located inside the base (Fig 2).
Warning: Bulb may get hot, allow to cool
completely before touching.
3. Insert the pump outlet into the water tube and align the arrow marking of fountain
top with arrow marking at the edge of the base, so that the fountain top stands on
the base securely (Fig 3 & Fig. 4).
4. Fill fountain base with enough clean water to completely cover the water pump, the
water level should be even with the watermark. Place river rocks on the platform
for decoration (Fig 5), Plug the cord into 120V household outlet. The fountain is
controlled by the switch located on the power cord, If pump doesn't operate, rotate
in-line switch once to turn" on " and once more turn off.
Note: Ensure that the electrical cord loops below the electrical outlet to form a
"Drip Loop". This will prevent water from running down the cord into the electrical
outlet (Fig 7).
5. Arrange the river rocks as
you like. If splashing occurs,
rearrange the river rocks. If
water is not flowing properly
out of the upward jets, use
the cleaning pin (included)
and push through the
upward jets for maximum
water flow (Fig 6).
Maintenance
Changing light bulb
First, unplug fountain and let
F. Adaptor
bulb cool down. Remove the
bulb from the rubber plug in the
plastic tube. Gently pull the rubber plug
together with the bulb cover out from the
plastic tube and slowly pull apart.Use cau-
tion with glass tube. Insert the rubber plug
back into the plastic tube. Pull bulb straight
out from rubber neck. Replace with new
bulb, inserting prongs into the holes. Place
bulb cover securely onto rubber neck and
slide together into rubber of plastic tube
(Fig 8).
Fig. 2
Base
Flat surface
Base
Light bulb
Cord slot
Light
holder
Fig. 3
Outlet
Pump
5
Fountain top
Water tube

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wfl-npli

Tabla de contenido