EGO ST1530 Manual Del Operador página 22

ADJUSTING CUTTING LINE
LENGTH
The trimmer head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or worn,
additional line can be released by lightly
tapping the trimmer head on the ground
while operating the trimmer (Fig. 11).
WARNING:
the line cutting blade assembly. Excessive line length will cause the motor to overheat
and may result in serious personal injury.
For best results, tap the trimmer head on bare ground or hard soil. If line release is
attempted in tall grass, the motor may overheat. Always keep the trimming line fully
extended. Line release becomes more difficult as the cutting line becomes shorter.
LINE REPLACEMENT
NOTICE: Always use the recommended nylon cutting line with diameter no more than
0.095 in. (2.4 mm). Using line other than that specified may cause the string trimmer to
overheat or become damaged.
WARNING:
off and become dangerous projectiles.
1. Remove the battery pack from the
trimmer.
2. Remove the remaining cutting line,
if necessary. Simply pull it out by
hand.
3. Rotate the spool retainer in the
direction indicated by the arrow, as
necessary, to align the LOAD line on
the spool retainer with the eyelets in
the spool base (Fig. 12).
22
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC
Do not remove or alter
Never use metal-reinforced line, wire, or rope, etc. These can break
11
12
Eyelet
Arrow Direction
LOAD Line