golmar T-540 Plus SE Guía Rápida página 3

PROGRAMMING
Locate the SW2 DIP switch situated on the top left-hand side of the back
of the EL632/PLUS module and set number 2 to ON. The door panel will
reproduce a sound to advise that the system has entered into
programming mode.
Important: To perform this programming, the telephone's SW1 DIP
switches should be set to OFF .
Switch off the telephone to be programmed.
Once switched off, press the door release button.
While keeping the door release button pressed, switch on the telephone.
To show that the system is ready for programming, the door panel and the
telephone handset will emit a number of tones (the LED on the
telephone will illuminate red), enabling the door release button to be
released. To establish audio communication with the door panel, lift the
handset.
Press the button of the door panel that will call this telephone.
At this moment, the door panel and handset will emit a number of tones
(the LED on the telephone will blink red).
To programme the telephone as , press button
Master
(the telephone's LED will illuminate red).
To programme it as Slave 1 , press button
will blink (green) once. Continue successively to
button four times, and the status LED will blink (green) four times.
To programme the telephone as Slave + Intercom
the LED will blink (green) once. Then press button
telephone's LED will illuminate red).
Make a call to check that the telephone has been successfully
programmed. Programme the other telephones in the same way.
Once the programming has finished, set the programming switch to OFF.
Each apartment must only have one master unit; if there are parallel
telephones or monitors, they must be configured as slaves.
IMPORTANT: To programme the telephone with a coded door panel or from
a general door panel, see the manual of the corresponding door panel.
M
for 3 seconds
S
once, and the status LED
Slave 4 , pressing
SI
, press button and
for 3 seconds (the
IMPORTANT: For advanced programming, optional connections and more
information, see the T-540 PLUS
https://doc.golmar.es/search/manual/50122199
P
rogramming the telephone with a button door
panel.
" SE User Manual (code 50122199). "
4
T-540 Plus SE Telephone
Plus Digital System
QUICK GUIDE
GOLMAR S.A.
C/ Silici, 13
08940- Cornellá de Llobregat
SPAIN
Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis .
Golmar reserves the right to make any modifications without prior notice.
Code 50122199
golmar@golmar.es
Sistemas de comunicación S.A.
T-540 PLUS SE EN Q G REV.0218
www.golmar.es