Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
JUMO plastoSENS T04
Surface-Optimized Plastic Temperature Probe
(1)
(2)
(3)
(4)
(1) Pipe
(2) Surface-optimized plastic temperature probe
(3) Insulation cap
(4) Pipe clip
1.
Check the dimensions of the radius (e.g. 12 mm) on the probe (2).
2.
Insert the probe (2) with the radius pointing upwards into the insulation cap (3).
3.
Push the mounted measuring group (probe and insulation cap) from one side into the pipe clip (4) as far as it will go.
Make sure that the measuring group is seated correctly – it must not be tilted.
4.
Mount the complete module (probe, insulation cap, and pipe clip) completely on the pipe (1). Start with one side of the module.
5.
To complete the installation, clamp the entire module completely on the pipe (1).
V2.00/DE-EN-FR-ES/00718018
3/5
90400400T94Z000K000
Publicidad
