camry Premium CR 7910 Manual De Uso página 6

C. Temperature down button 16-31°C
E. Sleep mode button
G. Timer button
CONTROL PANEL operation – picture D
Press button "A" to turn on and turn off the machine, the buzzer will play signal once.
Cooling mode -
After machine turns on, default value is cooling mode with 22℃ and low fan speed.
- Press button "B" to select cooling mode between cooling mode
control lamp J turns on .
- Press button " C" or " D" to adjust required temperature from 16℃ to 31℃), buttons are not available in fan or
dehumidifying mode.
Fan mode -
- Press button "B" to select fan mode, fan mode control lamp "L" turns on .
- Press button "F" to select high speed or low speed, chosen speed control lamp "O" turn on.
- During fan mode operation the temperature and sleeping functions cannot be setup.
Timer mode -
- When the device is not working, press button "G", the LCD screen flashes, press the button "G" repeatedly to
setup the time the device will start to operate and how many hours it should operate. The LCD screen stops
flashing and timer control lamp "P" turns on.
- When the device is working, press button "G", the LCD screen flashes, press the button "G" repeatedly to setup
the time the device will shut off and how many hours it should operate before it will shut off. The LCD screen stops
flashing and timer control lamp "P" turns on. This is a delayed start function.
Dehumidifying mode –
- Press button "B" to select dehumidifying mode, dehumidifying mode control lamp "K" turns on .
- Under dehumidifying mode, sleeping function cannot be setup, and fan speed is low.
Sleep mode –
- Press button "B" to cooling mode.
- Press button "E" enter into sleeping mode, default value of fan speed is low.
- The sleep mode control lamp "N" turns on.
- The sleep mode is automatically programmed. After the first hour of operation, the temperature will increase by 1
℃, after the second hour of operation, the temperature will increase by another 1 ℃, and then remain at the same
level.
Sleep mode is not available in dehumidify and fan modes. When the device communicates that it is full of water -
the "M" indicator light flashes, then the device's standby mode, mode conversion and sleep mode will be cancelled
.
Air oscillation - Swing function –
Press button "I", after the device turns on, swing function control lamp "R" turns on, the louver will swing
continuously left and right; by pressing the button again the movement will stop and the louver remain in that
position.
D. Temperature up button 16-31°C
F. Fan speed button
H. Swing function button
→ →
fan mode dehumidifying mode. The cooling mode
6