Kreg KCT El Manual Del Propietario página 4

Clamp Blocks (I) are used for squaring rectangular frames, especially
cabinet face frames, and positioning the frame members so the pad of
3" [76mm]-reach bench clamp is over the pocket-hole joint.
Each block is marked with four stock widths: 11/2" [38mm] and 3"[76mm]
on one side and 2" [51mm] and 21/2" [64mm] on the other side. To set
up the block, find the mark that equals or is closest to the width of your
frame stock. With this side of the block facing up, insert a T-slot bolt (J)
through the hole in the alignment tab on the bottom of the block. Thread
With the desired width mark on the block facing the interior of the Clamp
Table, slide the alignment tab and T-slot bolt into the Clamp Trak. Two
Clamp Bocks on each Clamp Trak ensure that your frame is square.
Position Bench Clamps and Clamp Blocks as necessary along the Clamp
Track to secure the frame members.
See the entire line of Clamp System Components at: www.kregtool.com
Dry glue can be scraped off the melamine surface of the table top with a putty knife. Increase the ease of removing
glue by waxing the surface. Periodic cleaning extends the life of the table top.
Should you need to replace the top contact Kreg Customer Service at 1.800.477.8638 or through our Web site at
www.kregtool.com
Assembly
CLAMP BLOCKS
on knurled nut (K).
Maintenance
Alignment
Tabs
Alignment
Tabs
2"
2" mark