Important Safeguards - Andis BTF Instrucciones De Uso Y Cuidado

E N G L I S H
Please read the following instructions before using your new Andis
trimmer. Give it the care that a fine precision built instrument deserves
and it will give you years of service.

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should
always be followed, including the following: Read all
instructions before using the Andis trimmer.
DANGER:
To reduce the risk of electric shock:
1. Do not reach for an appliance that has fallen into water.
Unplug immediately.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be
pulled into a tub or sink. Do not place in or drop into
water or other liquid.
4. Except when charging, always unplug this appliance
from the electric outlet immediately after using.
5. Unplug this appliance before cleaning.
WARNING:
To reduce the risk of burns, fire,
electric shock, or injury to persons:
1. Close supervision is necessary when this appliance is used
by, on or near children or individuals with certain disabilities.
2. Use this appliance only for its intended use as described in
this manual. Do not use attachments not recommended by
manufacturer.
3. Never operate this appliance if it has a damaged cord
or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water. Return the
appliance to a service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any opening. Insert
only recharging transformer plug into trimmer receptacle.
2
6. Do not use outdoors or operate when aerosol (spray)
products are being used or where oxygen is being
administered.
7. Do not use this appliance with a damaged or broken
blade or comb as injury to the skin may occur.
8. Always attach plug to appliance first, then to outlet.
To disconnect, turn all controls to "off" then remove plug
from outlet.
9. Adjust voltage setting before connecting appliance to outlet.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
To start trimmer, move ON/OFF switch button to ON position, to stop,
move switch button back to original position.
CHARGING UNIT
The trimmer is not charged at the factory. Please charge trimmer for
12 hours (overnight) before first use for maximum performance.
Remove trimmer and AC adapter from carton. The dual voltage adapter will
have to be set manually to the correct voltage before plugging into an
electrical outlet. In the U.S.A., adapter must be at 120V setting (Figure A).
Plug adapter into a 120V (or 240V AC outlet, as according to your local
power standards). Note that the trimmer ON/OFF switch must be in the OFF
position for the battery to charge. Plug adapter cord directly into bottom of
the trimmer (Figure B). The green light on the trimmer will turn on.
You can keep the trimmer plugged into the adapter when not in use. The
adapter will maintain the battery at full charge and the green light will stay
on. The unit has a nickel metal hydride battery that cannot be damaged by
overcharging. However, we recommend that the adapter be unplugged if
the trimmer won't be used for seven or more days.
PLEASE NOTE: Nickel metal hydride batteries have less "memory effect"
than nickel cadmium batteries. Memory effect is caused by repeated short
uses of the trimmer, followed by charging. The battery never fully discharges
and, therefore, "forgets" how much energy it can store. In order to
maximize the performance of your nickel metal hydride battery, please
follow these steps:
3