Worx Professional Sonicrafter WU675 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 51
Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
This product has been marked with a symbol relating
to removing electric and electronic waste. This means
that this product shall not be discarded with household
waste but that it shall be returned to a collection system
which conforms to the European Directive 2002/96/CE.
It will then be recycled or dismantled in order to reduce
the impact on the environment. Electric and electronic
equipment can be hazardous for the environment and for
human health since they contain hazardous substances.
All manuals and user guides at all-guides.com
8
Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTeNded use
The power tool is intended for sawing and separating wooden
materials, plastic, plaster, non-ferrous metals and fasteners (e.g.
nails and clamps) as well as for working on soft wall tiles and for
dry grinding of small surfaces. It is especially suitable for working
close to edges and for flush cutting.
BeFORe PuTTING INTO OPeRATION
A) CHARGING THe BATTeRY
The battery charger supplied is matched to the Li-Ion battery
installed in the machine. Do not use another battery charger.
The Li-Ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to
cool down before recharging.
When the battery pack is charged for the first time and after
prolonged storage, the battery pack will accept a 100% charge
after several charge and discharge cycles.
B) TO ReMOVe OR INsTALL BATTeRY PACK (see Fig. A)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it back into
your tool. A simple push and slight pressure will be sufficient.

Publicidad

Tabla de contenido
loading

Tabla de contenido