Skoda 3V9 017 222 Instrucciones página 11

Grille – Longitudinal grille, grille partition to di-
vide the luggage compartment (attached to the
transverse grille)
The accessories are intended for professional fitting. ŠKODA AUTO recommends that they are
fitted by a contractual partner.
Component index for the grille set (fig. 1)
Component
Grille
M8 bolt
Cover cap (into the boot lid latch striker cover)
Adapter (into the boot lid latch striker cover)
M8 rivet nut (hex)
Adapter (into the ridge for attaching the rear
seat backs)
Template (for marking the hole to be drilled
in the boot lid latch striker cover)
Fitting instructions
Note
Only for vehicles with solid floors.
If the rivet nuts are ever lost, you can order more from the ŠKODA Original Accessories
catalogue using part number 3T9 071 754.
List of special tools
Hole saw bit (23 mm diameter) for drilling the hole in the latch striker cover.
Riveting tongs for M8 rivet nuts, e.g. V.A.G. 1765B, order number ASE 451 499 00 000
– for riveting the rivet nut (E) in the hole drilled in the panel behind the latch striker cover.
Tool for screwing in the adapter (D)
- M8 x 50 bolt, M8 nut with washer, open-end wrench WAF 13.
3 mm drill bit, pin, dust extractor.
Important fitting information
Remove the luggage-compartment floor covering from the vehicle.
Fit the grille as shown in the figures in the instructions (for locations for positioning the
attachment points, see arrows in fig. 2).
Caution: When drilling, remove the swarf using the suction device in
order to avoid damaging the interior luggage compartment lining.
Fitting procedure
How to make the attachment point for attaching the grille to the rear seat-back attach-
ment ridge:
Quantity Item
1
2
1
1
1
1
1
1
A
B
C
D
E
F
G
11
EN