Installing The Sound Bar; Falling Prevention - Sharp HT-SL50 Manual De Montaje

System preparation (continued)
■
Fixing wall mount angle
1
Fix the pattern paper to the wall in horizontal
position as below.
523 mm
Wall surface 30 mm
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
8-9 mm (3/8")
Wall surface
3
Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall
surface.
8-9 mm (3/8")
Wall surface
4
Screw the wall mount angle to the wall as shown in
the illustration. (Total screw is 4 pieces)
Wall mount angle
Wall mount
angle
(screws x 2)
Wall surface
(screws x 2)
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
All manuals and user guides at all-guides.com
30 mm
Pattern paper
32 mm (1-1/4")
32 mm (1-1/4")
Wall
Wall
mount
surface
angle
Wall surface
■

Installing the sound bar

1
Align the wall mount slot at the sound bar to the
wall mount angle.
2
Slot the sound bar into the wall mount angle.
3
Fix them securely.
Wall surface

Falling prevention

Safety wires (not supplied) are useful to prevent the sound
bar from falling off the table.
Loop the safety wires (not supplied) into each hole as
shown and tie the safety wires to the LCD TV stand.
E-5