Mobile App And Wi-Fi Connection - cecotec CONGA 2290 Manual De Instrucciones

ENGLISH
Oscillating orange light: Charging
Red light blinks: Error
Notes:
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.
Wet & dry tank installation
Recommendation: It is not suggested to use the scrubbing function for the first-time use.
Open the tank's blue silicone lid, fill the tank with water carefully so water does not come out
and close it again.
Make sure the clip is properly closed to avoid water from pilling.
Fig. 14.
Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened.
Fig. 15.
Attach the mop to the bottom part of the mop bracket with the Velcro.
Fig. 16.
Manually press the tabs on both sides of the mop bracket and push it into its correct position.
You will hear a click when it is properly fixed. To remove it, press the Wet & dry tank release
button and pull from the Wet & dry tank.
Fig. 17.
Recommendations:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
Add some drops of cleaning agent (not corrosive) if considered necessary.
Fig. 18.
Warnings:
Using cleaning agents in excess might block water outlets.
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
5. OPERATION
Once the robot's light indicator changes from oscillating orange to steady blue, the battery is
30
fully charged and the robot is ready to operate.
The robot cannot operate with low battery.
Remove all cables and obstacles from the floor before operating the robot in order to avoid
accidents and damage.
Robot buttons
Auto mode
From the standby mode, press the power button on the remote control or on the App and the
robot will automatically start operating. It will carry out a cleaning cycle in zigzag motion and
then another one in Edge mode. Once it has finished, it will return to the charging base.
It is the most commonly used cleaning mode and it is used to efficiently clean the whole house's
surface. The robot vacuums the floor's dust automatically, in and organized and efficient way,
as it features memory and gyroscopic navigation supported by its camera.
Moreover, it changes direction when it finds obstacles throughout its route and it returns to
the charging base in a smart and direct way once the cleaning is over. It includes Total Surface
function, through which the robot cleans the whole surface and, if necessary, returns to the
charging base to recharge its battery and finish cleaning.
Back home mode
The Back home mode can be activated at any point of any cleaning cycle. Once it is activated,
the robot will automatically return to the charging base.
Warning: Make sure not to charge the robot with the Wet & dry tank installed when it contains
water.

6. MOBILE APP AND WI-FI CONNECTION

In order to access all the robot's functions from wherever you are, it is suggested to download
the Conga 2000 App. You will be able to control the robot in the most efficient way, enjoying
the excellence of cleaning.
App advantages:
Control your robot in an easy and intuitive way.
Activate the cleaning process from any point.
Carry out settings and daily scheduling.
Choose between its different cleaning modes: Auto, Edge, Random, Twice, Scrubbing, Manual,
Back home, Spiral, Spot and Smart Area.
View how the robot creates an interactive map as it is cleaning.
ENGLISH
31