Craftsman 900.370510 Manual Del Usuario página 13

598994-00,37051 8/9/05
BLADE CARE
For best results, mower blade must be
kept sharp. Replace bent or damaged
blades.
CLEANING
• Release Operator Presence Control
Switch to turn mower off, wait for the
blade to stop, and unplug mower!
• Turn off, let the blade come to a stop
and then unplug mower!
• Use only mild soap and a damp cloth to
clean the mower. Clean out any clippings
which may have accumulated on the
underside of the deck.
PRODUCT SPECIFICATIONS
MODEL NUMBER
POWER
BLADE SPEED
CUTTING WIDTH
BLADE BOLT TORQUE:
CAUTION: Before performing any ser-
vice or adjustments:
• Release operator presence control
switch and stop motor.
• Make sure the blade and all moving
parts have completely stopped.
• Unplug power cord.
REAR DEFLECTOR
The rear deflector, attached between the
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
• Clean entire lawn mower (See
"CLEANING" in the Maintenance section
of this manual).
• Be sure that all nuts, bolts, screws, and
pins are securely fastened. Inspect
10:17 AM Page 13
PREVENTING CORROSION
• Fertilizers and other garden chemicals
contain agents which greatly accelerate
the corrosion of metals. If you mow in
areas where fertilizers or chemicals have
been used, the mower should be
cleaned immediately after use.
• CAUTION: DO NOT pour or spray
water on the mower.
• Do not store the tool on or adjacent to
fertilizers or chemicals. Such storage can
cause rapid corrosion.
900.370510
120v 12 Amp
3600 RPM
19''
20-30 FT. LBS.
SERVICE AND ADJUSTMENTS
rear wheels of your mower, is provided to
minimize the possibility that objects will be
thrown out of the rear of the mower into
the operator mowing position. If the
deflector becomes damaged, it should be
replaced.
TO ADJUST CUTTING HEIGHT
To adjust cutting height refer to "Adjust
Cutting Height" in Operation section of this
manual.
STORAGE
moving parts for damage, breakage and
wear. Replace if necessary.
HANDLE
You can fold your lawn mower handle for
storage.
• Ensure that the power cord has been
unplugged.
• Loosen both handle knobs.
• Carefully fold the handle forward over
the mower.
CAUTION: DO NOT pinch cord
between handle and mower shroud.
13